Brother MFC-9650 Manual Do Utilizador
111
S E T T I N G U P T H E M A C H I N E A N D C O M P U T E R T O W O R K T O G E T H E R
2
Attach the Filter core, pressing until you hear a click, between the
Parallel Interface connector and the Cable tie.
Parallel Interface connector and the Cable tie.
to MFC
Double shielded
Parallel I/F cable
Parallel I/F cable
Cable Tie
Filter Core
Filter Core
Installing the Software/Drivers under
Windows
Windows
®
for MFC-9650
All the software and drivers are supplied on a single CD. An Auto-Install
program will guide you through most of the installation process.
program will guide you through most of the installation process.
1
Make sure that your machine is connected to your computer and that
the machine is switched on.
the machine is switched on.
2
Turn your computer on and start Windows
®
.
3
Insert the CD-ROM into your CD-ROM Drive. Windows
®
95/98/NT4.0 will be detected automatically, and if possible the Auto-
Installer will run automatically. If the Auto-Installer does not run
after a few seconds, you can run it by:-
Installer will run automatically. If the Auto-Installer does not run
after a few seconds, you can run it by:-
A) Click the START button and then select RUN from the
Start Menu.
B) Type X:\SETUP.EXE” [where X is your CD-ROM Drive] in
the command line box.
C) Click on OK.
YOU CAN EXIT FROM THE AUTO-INSTALLER AT ANY TIME BY
CLICKING ON THE ICON IN THE BOTTOM RIGHT HAND
CORNER OF YOUR SCREEN.
CLICKING ON THE ICON IN THE BOTTOM RIGHT HAND
CORNER OF YOUR SCREEN.