Yamaha DSP5D Manual Do Utilizador

MON/CUE function

236

PM5D/PM5D-RH V2 / DSP5D Owner’s Manual

Reference section

’Here you can make settings and perform operations
related to the internal oscillator.

A OSC ON/OFF (Oscillator on/off)

Turns the Oscillator on/off. This is linked with the
OSCILLATOR [ON] switch of the top panel.

B OSC MODE (Oscillator mode)

These buttons select the waveform or type of noise pro-
duced by the oscillator.

SINE WAVE 1CH  . Sine wave x 1 channel
SINE WAVE 2CH  . Sine wave x 2 channels
PINK NOISE   . . . . . Pink noise
BURST NOISE . . . . Burst noise (repeated output of

pink noise)

C PARAMETERS

Here you can set various items according to the selec-
tion in (

• If SINE WAVE 1CH is selected

• If SINE WAVE 2CH is selected

• If PINK NOISE is selected

• If BURST NOISE is selected

D LEVEL

This knob adjusts the output level of the oscillator. The
range is –96 dB to 0 dB. The level meter beside the
knob indicates the output level.

E FREQ (Frequency)

This knob specifies the frequency of the sine wave pro-
duced by the oscillator. The range is 20 Hz–20 kHz (the
current setting is shown in the numerical box below).
You can use the 10 kHz /1 kHz / 100 Hz buttons to
select a preset frequency.

Hint

If SINE WAVE 2CH is selected, you can specify the level and
frequency of each channel independently.

F HPF (High Pass Filter)
G LPF (Low Pass Filter)

Here you can make settings for the HPF/LPF through
which the pink noise or burst noise is sent. The knob
above sets the cutoff frequency (20 Hz–20 kHz), and
the button below switches the filter on/off.

OSCILLATOR screen

OSCILLATOR