Yamaha DSP5D Manual Do Utilizador

H WIDTH
I INTERVAL

If burst noise is selected, these knobs select the dura-
tion of the noise itself (WIDTH) and the duration of 
silence between noise bursts (INTERVAL).
The range is 0.1–10 sec for WIDTH, and 1–30 sec for 
INTERVAL. (The current setting is shown in the box 
below each knob.)

J OSC OUT (Oscillator direct output)

This indicates the channel of the output jack / slot that 
directly outputs the oscillator signal. If you want to 
change the output destination, click the PATCH but-
ton to access the OUTPUT PATCH screen.
If SINE WAVE 2CH is selected, the L channel of the 
oscillator is sent to the oscillator direct output.

K BUS ASSIGN

Here you can select the bus(es) or output jack(s) from 
which the sine wave or noise will be sent. (Multiple 
selections are allowed.)

MIX 1–24   . . . . . . . . MIX bus 1–24
MATRIX 1–8 . . . . . . MATRIX bus 1–8
AL/AR   . . . . . . . . . . . STEREO A bus L/R channels
BL/BR   . . . . . . . . . . . STEREO B bus L/R channels

If SINE WAVE 2CH is selected, the L channel of the 
oscillator is output to the odd-numbered bus or the L 
jack, and the R channel of the oscillator is output to the 
even-numbered bus or the R jack.

This screen contains various settings and indications for 
2TR IN / 2TR OUT.

A Input level meters

These indicate the input level of 2TR IN DIGITAL 
jacks 1–3 and 2TR IN ANALOG jacks 1–2.

B FREQUENCY (Sampling frequency)

Indicates the sampling frequency of the input signal 
from 2TR IN DIGITAL jacks 1–3.

C SRC (Sampling Rate Converter)

These are on/off switches for the sampling rate con-
verters built into 2TR IN DIGITAL jacks 1–3.
(If turned off, this indicates “THROUGH.”)

D EMPHASIS STATUS

Indicates whether emphasis processing is being applied 
to the input signal from 2TR IN DIGITAL jacks 1–3.

INTERVAL

WIDTH

Level

Time

Pink noise output

The BURST NOISE button is on

J

K

1

2
3
4