APC AP7900 Manual Do Utilizador
®
USER’S GUIDE
Switched Rack PDU
78
Use the
Port
setting to identify the TCP/IP port that the FTP server uses for
communications with the Rack PDU. The default
Port
setting is
21
.
You can change the
Port
setting to any unused port from
5000
to
32768
to
enhance the protection provided by
User Name
and
Password
settings.
You must then use a colon (:) in the command line to specify the non-default
port. For example, for a port number of 5000 and a Rack PDU IP address of
159.215.12.114, you would use this command:
port. For example, for a port number of 5000 and a Rack PDU IP address of
159.215.12.114, you would use this command:
ftp 159.215.12.114:5000
Telnet/SSH
Use the
Telnet/SSH
option to perform the following tasks:
• Enable or disable Telnet or the Secure SHell (SSH) protocol for remote
control console access.
– While SSH is enabled, you cannot use Telnet to access the control
console.
– Enabling SSH enables SCP automatically.
FTP transfers files without using encryption. For higher security,
use Secure CoPy (SCP) for file transfers. When you select and
configure Secure SHell (SSH), SCP is enabled automatically. To
configure SSH, see
use Secure CoPy (SCP) for file transfers. When you select and
configure Secure SHell (SSH), SCP is enabled automatically. To
configure SSH, see
. If you decide to use SCP for file
transfer, be sure to disable the FTP server.
To access a text version of the Rack PDU’s event or data log, see
.
When SSH is enabled and its port and encryption ciphers
configured, no further configuration is required to use
SCP. (SCP uses the same configuration as SSH.)
configured, no further configuration is required to use
SCP. (SCP uses the same configuration as SSH.)