Lucent Technologies R5SI Manual Do Utilizador
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-931
MMI-BD
10
Error Log Entries and Test to Clear Values
Notes:
a. The circuit pack stopped functioning or it was physically removed from the
system. The alarm logs approximately 11 minutes after the circuit pack
has been removed and/or the SAKI Sanity Test (#53) fails.
has been removed and/or the SAKI Sanity Test (#53) fails.
If the circuit pack is in the system and the red LED is on, follow the
instructions for a red alarm in
instructions for a red alarm in
in
. Also, see “Handling Common Port
Circuit Packs.”
b. This circuit pack has been busied out using the
busyout board PCSS
command.
c. There are more than four MMI circuit packs in the system. Remove the
circuit pack that generated the error in the error log by locating the slot
indicated by the error.
indicated by the error.
1.
Run the short test sequence first. If all tests pass, run the long test sequence. Refer to the appropriate
test description and follow the recommended procedures.
test description and follow the recommended procedures.
Table 10-264.
MMI-BD Error Log Entries
Error
Type
Type
Aux
Data
Associated Test
Alarm
Level
On/Off
Board
Test to Clear Value
0
1
0
Any
Any
Any
test board PCSS sh r 1
1 (a)
Any
None
MIN
ON
18 (b)
0
Busyout board PCSS
WNG
OFF
release board PCSS
217 (c)
0
None
WNG
ON
257 (d)
65535
Control Channel Loop Test
(#52)
(#52)
MIN
ON
test board PCSS r 3
513 (e)
4352
to
4357
to
4357
Uplink error from pack
769 (f)
Any
MMI Synchronization
Status Test (#1123)
Status Test (#1123)
None
1281 (g)
Any
Circuit Pack Restart Test
(#594)
(#594)
MAJ
ON
1538 (h)
Any
Software detected error
MIN
ON
1793 (i)
ANY
TSI XTalk (#6)
MIN
ON
test board PCSS l r 3
2049 (j)
Any
TSI Loop (#1108)
MAJ
ON
test board PCSS l r 3