Lucent Technologies R5SI Manual Do Utilizador
DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Object Repair Procedures
Page 10-1357
TAPE (Tape Unit) [G3iV1.1-286]
10
Status Request Test (#69)
This test requests the Maintenance/Tape Processor (MTP) firmware on the TN773
Processor circuit pack for the current Tape Unit status and displays the results.
Processor circuit pack for the current Tape Unit status and displays the results.
Tape DMA Latch Test (#230)
Also known as the
Tape Interface Test
, this test checks the shared RAM on the
TN770 Memory circuit pack. The test also checks the communication paths on
the TN773 Processor circuit pack.
the TN773 Processor circuit pack.
Table 10-411.
TEST #69 Status Request Test
Error
Code
Test
Result
Description/ Recommendation
1029 to
2051
2051
ABORT
Refer to the STBY-SPE (Standby SPE) Maintenance
documentation for a description of these error codes.
documentation for a description of these error codes.
9000’s
ABORT
Refer to Table A in
and follow the recommended repair strategy for
specific Aux Data.
Any
Others
Others
FAIL
Refer to Table B in
and follow the recommended repair strategy for
specific Aux Data.
PASS
This test verifies the basic communication between the
Processor and the Tape Drive circuit pack.
Processor and the Tape Drive circuit pack.
Continued on next page
Table 10-412.
TEST #230 DMA Latch Test
Error
Code
Test
Result
Description/ Recommendation
1029 to
2051
2051
ABORT
Refer to the STBY-SPE (Standby SPE) Maintenance
documentation for a description of these error codes.
documentation for a description of these error codes.
23001
ABORT
Could not allocate the necessary system resources to
run this test.
run this test.
1. Retry the command at one-minute intervals a
maximum of five times.
2. If the test continues to abort, escalate the problem.
Continued on next page