Lucent Technologies R5SI Manual Do Utilizador

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-166

enable synchronization-switch 

No defaults.

None.

If the system technician presses help after entering "enable 
synchronization-switch" the following message will be displayed:

 Entry is not required

If the command entered is in conflict with another currently executing command, 
then a message will be displayed showing the login id of the conflicting user and 
the conflicting command. The message is as follows:

 ’login id’:’command’ has a command conflict

If during the execution of a command a resource problem occurs that requires 
the user to restart the command, then the following message will be displayed:

 Command resources busy; Press CANCEL to clear, and then resubmit

If all of the available maintenance resources are currently in use, then the 
following message will be displayed:

 All maintenance resources busy; try again later

If the enable synchronization-switch command is successful, the following 
message will be displayed on the SAT:

 Command successfully completed

If the enable synchronization-switch command is unsuccessful, the following 
message will be displayed on the SAT:

 Error encountered, can’t complete request

If the enable command is run and synchronization-switch is currently enabled, 
the following message will be displayed on the SAT:

 Synchronization-switch already enabled

None.