Lucent Technologies R5SI Manual Do Utilizador

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids 

Page 8-344

set expansion-link 

If the format of the specified expansion interface circuit pack is invalid, the 
following message will be displayed:

Port/Board invalid

If the link associated with the entered EI location is already active, the following 
message will be displayed:

EXP-INTF is already on active link

If the specified expansion interface is not configured in the system, the following 
message will be displayed:

Board not assigned

If the specified expansion interface is already the active link, the following 
message will be displayed:

EXP-INTF is already on active link

If the specified expansion interface is unable to become active, the following 
message will be displayed:

Standby EXP-INTF Link is unable to take over

If there are no maintenance objects for the specified board, the following 
message will be displayed:

No MO in this board

If the specified board is not an expansion interface board, the following message 
will be displayed:

Address is not a valid Expansion Interface Board

If the command entered is in conflict with another currently executing command, 
then a message will be displayed showing the login id of the conflicting user and 
the conflicting command. The message is as follows:

’login id’:’command’ has a command conflict

If during the execution of a command a resource problem occurs that requires 
the user to restart the command, then the following message will be displayed:

Command resources busy; 

Press CANCEL to clear, and then resubmit

If all of the available maintenance resources are currently in use, then the 
following message will be displayed:

All maintenance resources busy; try again later