Symmetricom 1100 Manual Do Utilizador

Chapter 4 Provisioning the TimeProvider
Provisioning NTP Parameters

122  TimeProvider User’s Guide

Use the ED-SYNC command to set the cut-thru mode for each port (1 or 2) on the 
Retimer module. You can enable cut-thru mode when the local oscillator (LO) enters 
either the free-run or holdover mode.

ED-SYNC:[<tid>]:<aid>:[<ctag>]::<keyword>=<value>;

This command has a default access level of ADMIN.

ED-EQPT::RTMA-1:TS1000::FREEFLT=CUTTHRU;

This command sets the Retimer to enter cut-thru mode when the local oscillator 
enters free-run mode.

TP-SSU 03-10-24 11-09-12

A 1189 REPT EVT

“RTMA,EQPT:NA,OUTSTATE,NSA,03-10-24 11-09-12:\"CUTTHRU 

STATE HAS CHANGED,CUTTHRU\””

;

This section describes how to enable and provision the Network Time Protocol 
(NTP) feature in the TimeProvider. There are TL1 commands that allow you to:

Activate the NTP feature

Edit the NTP parameters

RTMg[-p]
g = A | B | C | D 
p= 1 | 2

FREEFLT

CUTTHRU

Cut-thru mode is engaged 
when the LO enters 
free-run mode.

RETIME

RETIME

Cut-thru mode is not 
engaged when the LO 
enters free-run mode.

HOLDFLT

CUTTHRU

Cut-thru mode is engaged 
when the LO enters 
holdover mode.

RETIME

RETIME

Cut-thru mode is not 
engaged when the LO 
enters holdover mode.