Cisco 2500 IP/FW Plus IPSEC 56 Feature Pack CD25-CHL-12.0= Manual Do Utilizador

16 Release Notes for Cisco IOS Release 12.0(6) Feature Packs for the Cisco 2500 Series

During the transfer process, messages indicate that the software has accessed the file you
have specified and is loading it.

If the software cannot find the file, check the following:

•

The filename is correct.

•

The TFTP server is enabled.

•

The correct root directory is selected.

•

There is IP connectivity between the router and TFTP server.

If the software still cannot find the file, create a temporary directory called “C:\temp,” and
copy the CiscoPro upgrade file into the directory. Select the C:\temp directory as the root
directory.

To erase the existing image in the router Flash memory before copying the new one, enter
yes:

Erase flash device before writing? [confirm] yes

The entire copying process takes several minutes and differs from network to network.
The exclamation point (!) indicates that the copy process is taking place. Each
exclamation point indicates that ten packets have been transferred successfully. If you see
three or more periods (...), the transfer may have failed. If so, use the ping command to
check IP connectivity between the router and TFTP server.

Enter the reload command to reload the router:

Router# reload

Do not save the configuration.

After the reload is complete, your CiscoPro router has been upgraded to a Cisco
Enterprise router. Because the original Cisco IOS image that resided in Flash memory
was erased during the upgrade process, the router is now running in bootstrap mode.

At the prompt, enter your password:

Password: <

password

>

At the prompt, enter enable; then enter your password:

Router# enable

Password: <

password

>

At the prompt, enter the following command to copy the new software image from the PC
CD-ROM drive to the router:

Router# copy tftp flash

In the next series of steps, you download the Cisco IOS Release 12.0 images that you
want installed on your router.

At the prompt, enter the IP address of your PC, as shown in the following example:

Address or name of remote host [255.255.255.255]? 131.108.1.1

This is the IP address of your local PC, not that of the router.