Cisco 2500 IP/FW Plus IPSEC 56 Feature Pack CD25-CHL-12.0= Manual Do Utilizador

Release Notes for Cisco IOS Release 12.0(6) Feature Packs for the Cisco 2500 Series  17

At the prompt, enter the filename of the Cisco IOS Release 12.0 image to be copied to the
router, as shown in the following example:

Source file name? 80153209.bin

This example specifies the DOS image name of the IP feature set for Cisco 2500 series
routers (as shown in Table 4 in the “Feature Pack Overview Table” section on page 6).

At the prompt, enter the destination UNIX image filename and press Enter.

This is the name of the image file on the router—not the full pathname of the image on
the CD-ROM attached to the PC. Refer to Table 4 in the “Feature Pack Overview Table”
section on page 6 for the UNIX image filename.

Destination file name [80153209.bin]? c2500-i-l

During the transfer process, the software displays messages indicating that it has accessed
the file you have specified and is loading it.

At the prompt, enter yes if you want to erase the existing image copy resident in the router
Flash memory before copying the new one.

Erase flash device before writing? [confirm] yes

The entire copying process takes several minutes and differs from network to network.

The exclamation point (!) indicates that the copy process is taking place. Each
exclamation point (!) indicates that ten packets have been transferred successfully. A
checksum verification of the image occurs after the image is written to Flash memory.

Enter the reload command to reload the router:

Router# reload

After the reload is complete, the router should be running the required Cisco IOS image. Use the
show version command to verify it.

The following sections describe the documentation available for the Cisco 2500 series. These
documents consist of hardware and software installation guides, Cisco IOS configuration and
command references, system error messages, feature modules, and other documents.

Documentation is available as printed manuals or electronic documents, except for feature modules,
which are available online on CCO and the Documentation CD-ROM only.

Use these release notes with these documents:

•

•

•

•

If you upgraded a CiscoPro CPA2500 router, do not save the configuration when

prompted.