Campbell Hausfeld SDM-CVO4 Manual Do Utilizador
Instruction Manual
insert a small screwdriver into either the top or front slot, as appropriate, and push
to open the terminal spring. Strip any insulation from the wire to give 7 to 9 mm
bare wire. Push the wire into the opening, and, while holding it in position,
withdraw the screwdriver to release the spring. The wire will now be firmly held
in place. See Figures 4-1 and 4-2, below.
to open the terminal spring. Strip any insulation from the wire to give 7 to 9 mm
bare wire. Push the wire into the opening, and, while holding it in position,
withdraw the screwdriver to release the spring. The wire will now be firmly held
in place. See Figures 4-1 and 4-2, below.
Figure 4-1. Use of the Spring-Loaded Terminal Blocks (Top Position)
Figure 4-2. Use of the Spring-Loaded Terminal Blocks (Front Position)
You cannot reliably insert more than one solid-core wire into one terminal
connector unless the wires are soldered or clamped together. When inserting more
than one stranded wire, twist the bare ends together before insertion.
connector unless the wires are soldered or clamped together. When inserting more
than one stranded wire, twist the bare ends together before insertion.
5