Patton electronic MODEL 2707/I Manual Do Utilizador

 

15

 

10Base-T cross-over cable connection

 

The 10Base-T interface is configured as DTE (data terminal equipment), 
just like a 10Base-T network interface card in a PC. Therefore, it 
“expects” to connect to a 10Base-T Hub using a straight-through RJ-45 
cable. Refer to Figure 9 below and Figure 7 on page 14 to construct a 
cable to connect the 10 Base-T interface to a 10Base-T hub.

 

Connecting the 10Base-T Ethernet port to a hub

 

The Model 2707/I uses a 5VDC, 

2A universal input 100-240VAC, power supply (center pin is +5V). The 
universal input power supply has a male IEC-320 power entry connector. 
This power supply connects to the Model 2707/I by means of a barrel 
jack on the rear panel. Many international power cords are available for 
the universal power supply. 

 

The Model 2707/I powers up as soon as it is plugged into an AC 

outlet—there is no power switch.

1 (TD+)

2 (TD-)

1 (TD+)

2 (TD-)

3 (RD+)

6 (RD-)

3 (RD+)

6 (RD-)

1 (TD+)

2 (TD-)

1 (RD+)

2 (RD-)

3 (RD+)

6 (RD-)

3 (TD+)

6 (TD-)