Patton electronic MODEL 2707/I Manual Do Utilizador
17
6.0 OPERATION
When the Model 2707/I has been properly configured and installed, it
should operate transparently. This section describes power-up, LED sta-
tus monitors, and the built-in loopback test modes.
should operate transparently. This section describes power-up, LED sta-
tus monitors, and the built-in loopback test modes.
6.1 POWER-UP
Before applying power to the Model 2707/I, please review section “Power
Connection” on page 15 to verify that the unit is properly connected to
the appropriate power source.
Connection” on page 15 to verify that the unit is properly connected to
the appropriate power source.
6.2 LED STATUS MONITORS
The Model 2707/I features six front panel LEDs that monitor connections
on the G.703 and 10Base-T links, signaling, error and test modes.
Figure 11 shows the front panel location of each LED. Table 2 on
page 18 lists descriptions of each LED.
on the G.703 and 10Base-T links, signaling, error and test modes.
Figure 11 shows the front panel location of each LED. Table 2 on
page 18 lists descriptions of each LED.
Figure 11.
2707/I front panel
10Base-T