Omega Vehicle Security 1500 Manual Do Utilizador
3-4 General Information and Specifications
NetScan User’s Manual
Min channel configuration
16 channels
Max channel configuration
128 channels
General
Installation Category:
•
•
CE: Category 2 for Line Voltage Input terminal.
All other terminals are Category 1.
Warm Up:
•
•
1 hour to rated accuracy.
Expansion Connector:
•
•
40-conductor connector for connecting expansion chassis via ribbon cable.
NetScan’s expansion connector (PH401) is located on the analog backplane
board.
NetScan’s expansion connector (PH401) is located on the analog backplane
board.
Chassis Ground Connection:
•
•
Screw terminal.
Dimensions:
•
•
330 mm wide × 241 mm deep × 152 mm high (13” × 9.5” × 6”).
Weight:
•
•
≈ 4.3 kg (9.6 lbs.) with 4 signal conditioning cards installed
Operating Environment:
•
•
Standard: Indoor use, 0 to 50°C;
0 to 95% RH (non-condensing) to
35°C; linearly derate 3% RH/°C
from 35 to 50°C.
0 to 95% RH (non-condensing) to
35°C; linearly derate 3% RH/°C
from 35 to 50°C.
•
CE: Indoor use at altitudes below 2000 m,
5 to 40
5 to 40
°C; 0 to 80% RH up to 31°C
decreasing linearly to 50% RH at 40
°C.
Control:
•
•
Power Switch, Ethernet or RS-232/422 option, handshake, parity, baud rate,
calibration memory write enable/disable.
calibration memory write enable/disable.
Rear Panel LED Indicators:
•
•
ALARM, TRIGGER, SCAN, ERROR, and POWER
•
SEND and RECEIVE (for RS-232/422 serial interface only)
•
ACTIVITY, LINK, and ETHERNET (for Ethernet Interface only)
Power:
•
•
105-125V, or 210-250V, 50/60 Hz; 20 VA maximum. Set via internal,
two-position slide switch.
two-position slide switch.
Transient Overvoltage according to Installation Categories:
•
•
Overvoltage Category II for mains supply. The minimum and normal
category is II.
category is II.
Pollution Degree:
•
•
I
− in accordance with IEC 664
Channels
Number of Option Card Slots:
•
•
4
Number of Channels:
•
•
up to 64 channels, expandable to 128 with NetScan expansion chassis
•
16 channels per card
•
up to 4 cards installed in NetScan
(up to 4 additional cards with use of NetScan expansion chassis)
Channel Attributes:
•
•
High and low set points; hysteresis values for high and low set points.
Scan Sequence:
•
•
Any combination of temperature and voltage channels may be scanned, but
channels are scanned in ascending numerical order.
channels are scanned in ascending numerical order.