Nortel Networks NN44200-313 Manual Do Utilizador
Enabling card slots (LD 32)
29
Prompt
Response
Notes
KEY
0 SCR xxxx
Where xxxx is the line number
of the telephone. This is the
number dialled or the line
selected when the user makes
a call from the telephone.
of the telephone. This is the
number dialled or the line
selected when the user makes
a call from the telephone.
For example:
4710
4710
KEY
16 MWK xxxx
Where xxxx is the CDN of the
CallPilot system.
CallPilot system.
For example:
4300
4300
4
Repeat step 3 for each telephone to be configured.
Configure at least two telephones for testing purposes.
Configure at least two telephones for testing purposes.
5
To exit the overlay, enter ****.
6
Connect two telephones to either a phone line or a proper network
connection, depending on the telephone type. Refer to the user
guides specific to the telephones.
connection, depending on the telephone type. Refer to the user
guides specific to the telephones.
7
Ensure that you have dial tone on both telephones, and check that
you can dial one phone from the other.
you can dial one phone from the other.
—End—
Enabling card slots (LD 32)
If the MGATE card slots are not automatically provisioned, perform the
following procedure to enable them.
following procedure to enable them.
Step
Action
1
Connect to the PBX.
2
Enter LD 32.
3
To display the status of the MGATE card, enter STAT n (where n is
the card slot used by the MGATE).
For example: STAT 18.
the card slot used by the MGATE).
For example: STAT 18.
4
If the MGATE card is disabled, enter ENLC n (where n is the card
slot used by the MGATE) to enable it.
For example: ENLC 18.
slot used by the MGATE) to enable it.
For example: ENLC 18.
5
Repeat steps 3 and 4 for each required MGATE card.
Nortel CallPilot
Quickstart Guide
NN44200-313
01.02
Standard
5.0
19 May 2008
Copyright © 2007-2008, Nortel Networks
.