Nortel Networks BSG12aw Manual Do Utilizador
Basic procedures 65
Installation
1
Remove all of the cables from the unit.
To disconnect cables, see
2
If a unit is mounted to the top of another unit, slide that unit forward until it
disengages from the clips on the lower unit. Lift the unit off of the top of the lower
unit.
disengages from the clips on the lower unit. Lift the unit off of the top of the lower
unit.
3
Lift the unit off of the table.
4
Set the unit on a flat, clean, static-free surface.
End
Disconnecting the cables
Use this procedure to disconnect the cables from a BSG8ew/12ew/aw/tw.
Procedure steps
Step
Action
1
Remove the FXO RJ-11 connection.
2
Remove the FE connections from the LAN ports.
3
Remove the WAN connection from the WAN ports.
4
While disconnecting a BSG8ew, rotate the power supply retention clip to free the
power supply cord.
power supply cord.
5
Remove the power supply cord from the unit.
End
Connecting the cables
For connecting the cables, see
Caution: Risk of leakage currents
You must disconnect the telephony and data networking cables from the system
before disconnecting the power cord from a grounded outlet.
You must disconnect the telephony and data networking cables from the system
before disconnecting the power cord from a grounded outlet.