Nortel Networks 703t Manual Do Utilizador
Preinstallation requirements
Standard 1.04
42
CallPilot
Inspecting the server interior
Introduction
Before you install the server, you should perform a visual inspection for
loose components, foreign matter, or shipping damage inside the server.
loose components, foreign matter, or shipping damage inside the server.
To inspect the server interior
1 Ensure that all the cards are fully seated on the baseboard.
2 Check for any loose wires or foreign objects, such as loose screws,
inside the chassis.
3 Review the slot locations (see “Rear panel diagram” on page 21).
4 Do one of the following:
.
CAUTION
Risk of equipment damage
When working with interior components, use an ESD wrist
strap to protect static-sensitive components.
strap to protect static-sensitive components.
IF THEN
you observe
any damage
any damage
contact your Nortel technical support
representative.
representative.
components have
become loose
become loose
secure them. Then replace the server
side cover and proceed with the
hardware installation.
side cover and proceed with the
hardware installation.
Refer to the procedures in CallPilot 703t
Server Maintenance and Diagnostics
(555-7101-227).
Server Maintenance and Diagnostics
(555-7101-227).
you are satisfied that the
703t server has arrived at
your site undamaged
703t server has arrived at
your site undamaged
replace the server side cover.
For instructions, see “Replacing the side
cover” on page 43.
cover” on page 43.