ZyXEL Communications Prestige 642 Manual Do Utilizador
Prestige 642 PPPoE Modem
2-2
Hardware Installation & Initial Setup
2.2 Rear Panel and Connections of the P642
The following figure shows the rear panel connections of your Prestige.
Figure 2-2 Rear Panel Connections of the P642
2.2.1 Connecting the ADSL Line
Connect the Prestige directly to the wall jack using the included ADSL cable. Connect a microfilter between
the wall jack and your telephone(s) (see the Connecting a Microfilter figure). Microfilter(s) act as low pass
filters (voice transmission takes place in the 0 to 4KHz bandwidth). A microfilter is an optional purchase.
the wall jack and your telephone(s) (see the Connecting a Microfilter figure). Microfilter(s) act as low pass
filters (voice transmission takes place in the 0 to 4KHz bandwidth). A microfilter is an optional purchase.
2.2.2 Connecting a Computer to the Prestige 10/100M LAN Port
Ethernet 10Base-T/100Base-T networks use Shielded Twisted Pair (STP) cable with RJ-45 connectors that
look like a bigger telephone plug with 8 pins. Use the crossover cable (red tag) to connect your Prestige to a
computer directly. Use a straight-through Ethernet cable (white tag) to connect to an external hub and then
connect one end of a straight-through Ethernet cable (white tag) from the hub to the NIC (Network Interface
Card) on the computer.
look like a bigger telephone plug with 8 pins. Use the crossover cable (red tag) to connect your Prestige to a
computer directly. Use a straight-through Ethernet cable (white tag) to connect to an external hub and then
connect one end of a straight-through Ethernet cable (white tag) from the hub to the NIC (Network Interface
Card) on the computer.
2.2.3 Connecting the Power Adapter to your Prestige
Connect the power adapter to the port labeled POWER on the rear panel of your Prestige.