ZyXEL Communications Prestige 642 Manual Do Utilizador
Prestige 642 PPPoE Modem
2-4
Hardware Installation & Initial Setup
Figure 2-3 Connecting a POTS Splitter
Step 1. Connect the side labeled “Phone” to your telephone.
Step 2. Connect the side labeled “Modem” to your Prestige.
Step 3. Connect the side labeled “Line” to the telephone wall jack.
2.5 Default
Settings
Your Prestige is shipped with the following default settings:
¾
¾
VPI: 8, VCI: 35
¾
WAN interface: PPPoE LLC mode
¾
Console port speed: 9600 bps
¾
DHCP: Server
¾
Password: “1234”
Depending on your region, the default password and VPI/VCI may differ.
2.6 Turning On the Prestige
At this point, you should have connected the console port, the ADSL line, the Ethernet port and the power
port to the appropriate devices or lines. Execute the terminal emulation program if you plan to configure the
Prestige with the Command Line Interface. Turn the power switch (located on the back of your Prestige)
from OFF to ON to turn on your Prestige.
port to the appropriate devices or lines. Execute the terminal emulation program if you plan to configure the
Prestige with the Command Line Interface. Turn the power switch (located on the back of your Prestige)
from OFF to ON to turn on your Prestige.
• Proceed to the Web Configurator chapter if you want to configure the Prestige using the web
configurator. This is the most user-friendly configuration method.
• Proceed to the Command Line Interface chapter if you want to configure the Prestige using
the Command Line Interface.
Wall
Jack
Jack
Prestige
Modem
Line
POTS Splitter
Phone