Agilent Technologies 85225F Manual Do Utilizador

 

If the system will not be used with a probe station, install the work 
surface to facilitate in- fixture or coaxial measurements. 

The work surface is designed to fit onto the rack below the network 
analyzer. When the following procedure is performed properly, the work 
surface maintains a path to chassis ground through the support rails and 
the rack cabinet.

Follow these instructions to install the work surface.

• Medium Pozidriv screwdriver

• Small flat- blade screwdriver

To install the work surface

1 Prepare to install the work 

surface.

a Fully extend the four lock feet at the bottom 

of the rack cabinet.

b Unpack the work surface and the work 

surface support rails.

c Lay the rails down so that:

the ends with the single pemmed hole 
are facing the front,

the ends with the keyhole-shaped cutout 
are facing the rear,

and the rails are facing inward toward 
each other.

The lock feet prevent the cabinet from 
moving on the casters.

These are the positions of the support 
rails when installed in the rack.

2 Attach the support rails to 

the rack cabinet.

a Pass the large end of the keyhole-shaped 

cutout in each rail over the shoulder screw 
already mounted inside the rack.

b Slide the rails to the rear of the rack.
c Use one 1/2 inch long 10-32 Pozidriv screw, 

one split lock washer, and one flat washer 
to secure each rail.

d Before tightening the screws, ensure that 

the rails are level.

e Tighten the screws.

You may need to hold the rails in place 
as you tightened the screws.