Adtran MX412 Manual Do Utilizador
Integrated Wireless Access Device or DS0 Grooming
MX410/MX412 System Manual
3-14 PRELIMINARY
61189500L1-1B
Setup
Connect the DS1 from which the DS0s will be dropped to the DS1 1 RJ. Connect the other
DS1s to DS1 2, 3 and 4 RJ. For more information, refer to
Connect the DS1 from which the DS0s will be dropped to the DS1 1 RJ. Connect the other
DS1s to DS1 2, 3 and 4 RJ. For more information, refer to
Starting from the default mapping the DS0s can be mapped using the Quick Setup menu
shown in
shown in
. Select each port to which a DS0 needs to be dropped from the
incoming DS1. For each port select the DS0(s) in DS1 1 to be dropped to that port. Using the
Cross-Connect Mapping menu, select each DS0 that are to be mapped from other DS1 ports
as well. Select the Map Multiple DS0’s option and then select the range of DS0 and DS1 1 to
be dropped to DS1 2 and enable Robbed Bit Signaling if applicable.
For an integrated wireless access device application, map DS0s to the corresponding DS0 in
the other DS1 (DS1 2, 3, and 4 in this example). For a grooming application, each DS0
dropped out of the incoming DS1 (DS1 1 in this example), that does not have a DS0 dropped
or inserted into the corresponding DS0 in the other DS1 (DS1 2,3 and 4 in this example), map
the groomed DS0s to continue the data downstream. Any unmapped DS0 will transmit all
ones.
The following six figures show an example of setting up an integrated wireless access device or
grooming application.
Cross-Connect Mapping menu, select each DS0 that are to be mapped from other DS1 ports
as well. Select the Map Multiple DS0’s option and then select the range of DS0 and DS1 1 to
be dropped to DS1 2 and enable Robbed Bit Signaling if applicable.
For an integrated wireless access device application, map DS0s to the corresponding DS0 in
the other DS1 (DS1 2, 3, and 4 in this example). For a grooming application, each DS0
dropped out of the incoming DS1 (DS1 1 in this example), that does not have a DS0 dropped
or inserted into the corresponding DS0 in the other DS1 (DS1 2,3 and 4 in this example), map
the groomed DS0s to continue the data downstream. Any unmapped DS0 will transmit all
ones.
The following six figures show an example of setting up an integrated wireless access device or
grooming application.
shows the Quick Setup menu before any DS0s have been
dropped.
Figure 3-16. Quick Setup Menu
MX410 MM/DD/YY HH:MM
Active Alarms: CRITICAL MINOR ID: MX410
Active Alarms: CRITICAL MINOR ID: MX410
Quick Setup
Ports
1 - PPPs
Ports
1 - PPPs
2 - V.35 =
System
3 - System ID
4 - IP Address : 192.168.100.1
Subnet Mask : 255.255.0.0
5 - Default Gateway : 192.168.1.1
6 - Date
7 - Time 8 - Cross-Connect Mapping
3 - System ID
4 - IP Address : 192.168.100.1
Subnet Mask : 255.255.0.0
5 - Default Gateway : 192.168.1.1
6 - Date
7 - Time 8 - Cross-Connect Mapping
Selection : '?' - System Help Screen