Lucent Technologies PortMaster Manual Do Utilizador
Using ISDN BRI
12-5
Configuring ISDN
Setting the Switch Type
To set the ISDN switch type for an ISDN BRI U interface, use the following commands:
Command> set isdn-switch ni-1|dms-100|5ess|5ess-ptp
Command> reboot
Command> reboot
To set the ISDN switch type for an ISDN BRI S/T interface, use the following commands:
Command> set isdn-switch net3|vn4|1tr6|ntt|kdd
Command> reboot
Command> reboot
Note – You must reboot the PortMaster after changing the switch type for the change to
take effect.
take effect.
Service Profile Identifier (SPID) for ISDN BRI
The service profile identifier (SPID) is a unique number assigned by the telephone
company that identifies your ISDN equipment to the telephone company’s switch. SPIDs
are used with BRI ports only, and only in the United States. A SPID can have up to 20
digits. If you are connecting to a 5ESS point-to-point switch, a SPID is not required.
company that identifies your ISDN equipment to the telephone company’s switch. SPIDs
are used with BRI ports only, and only in the United States. A SPID can have up to 20
digits. If you are connecting to a 5ESS point-to-point switch, a SPID is not required.
To set the SPID and save the configuration to nonvolatile RAM, use the following
commands:
commands:
Command> set S0 spid Number
Command> save all
Command> save all
The set debug isdn on command shows any invalid SPIDs.
ntt
Japan
kdd
Japan
Table 12-2
International ISDN BRI Switch Types (Continued)
ISDN Switch Type
Used for
✍