Lucent Technologies PortMaster Manual Do Utilizador

Note – numberauto is off by default.

To change the number type from the default manufacturer setting (so that you can, for 
example, begin successfully to place outbound calls), use the following command:

Command> set isdn-numbertype 0|1|2|4

The new setting becomes effective immediately; it does not need to be saved to 
nonvolatile RAM.

Enter this command without a number type value to display a list of all plan values 
available, and the current setting.

To change the number plan from the default manufacturer setting (so that you can, for 
example, begin successfully to place outbound calls), use the following command:

Command> set isdn-numberplan 0|1|2|7|8

The new setting becomes effective immediately; it does not need to be saved to 
nonvolatile RAM.

Enter this command without a number plan value to display a list of all plan values 
available, and the current setting.

Multilink PPP V.120 is supported on analog and ISDN interfaces. The PortMaster accepts 
and detects both multiline load balancing and Multilink PPP connections. Multiple lines 
can be used to increase bandwidth, either using Multilink PPP as defined in RFC 1717 or 
using Lucent’s multiline load balancing.

To enable Multilink PPP, use the following command:

Command> set location Locname multilink on

✍