Lucent Technologies PortMaster Manual Do Utilizador
Using Internet Connections
16-7
Configuration Steps for an Internet Connection
For more information about asynchronous ports, refer to Chapter 5, “Configuring an
Asynchronous Port.”
Asynchronous Port.”
Configuring a Dial-Out Location
If you are using a continuous dial-out link, a location entry on the PortMaster must be
created for the location identified as isp1. This entry allows the PortMaster to establish a
connection with the ISP as soon as it is booted. The new location isp1 should be
configured with the values shown in Table 16-5, or as instructed by your ISP.
created for the location identified as isp1. This entry allows the PortMaster to establish a
connection with the ISP as soon as it is booted. The new location isp1 should be
configured with the values shown in Table 16-5, or as instructed by your ISP.
Table 16-5
Location Table Values
Setting
Command
Location name
add location isp1
Type
set location isp1 manual
(Change to continuous after testing the configuration.)
Protocol
set location isp1 protocol ppp
IP destination
set location isp1 destination 192.168.5.6
Netmask
set location isp1 netmask 255.255.255.0
RIP routing
set location isp1 rip broadcast
MTU
set location isp1 mtu 1500
Compression
set location isp1 compression on
Input filter
set location isp1 ifilter internet.in
Output filter
set location isp1 ofilter internet.out
Idle timer
set location isp1 idle 0
High-water mark
set location isp1 high_water 0
Dial group
set location isp1 group 1
Telephone number
set location isp1 telephone 5551212
Username
set location isp1 username office
(This value is provided by your ISP.)