Lucent Technologies PortMaster Manual Do Utilizador
Configuration Steps for Dial-In Access
17-10
PortMaster Configuration Guide
A user account must be set up on the PortMaster for each authorized network user.
Each new user usera, userb, and so on should be configured with the values shown in
Table 17-7.
Each new user usera, userb, and so on should be configured with the values shown in
Table 17-7.
You can also use SLIP or CSLIP instead of PPP. Refer to Chapter 7, “Configuring Dial-In
Users,” for more information about this configuration.
Users,” for more information about this configuration.
After you configure user table settings as shown in Table 17-7, enter the following
command to save the configuration:
command to save the configuration:
Command> save all
For more information about configuring user table values, refer to Chapter 7,
“Configuring Dial-In Users.”
“Configuring Dial-In Users.”
Testing the User Dial-In Setup
To test the configuration, follow these steps for each PortMaster set up for user dial-in
access:
access:
1.
Enter the following commands:
Command> set console
Command> set debug 0x51
Command> set debug 0x51
2.
Dial in to the PortMaster you are testing, using the username and password
you have created in either RADIUS, or the user table.
you have created in either RADIUS, or the user table.
Table 17-7
User Table Values for usera
Parameter
Command
Username
add netuser usera
Password
set user usera password passwd
Protocol
set user usera protocol ppp
Address type
set user usera destination assigned
Compression
set user usera compression on
RIP routing
set user usera rip off