McDATA 3000 Manual Do Utilizador

McDATA UltraNet Edge 3000 User Guide

5. Select either Dedicated Circuit, Fail Over, or Load Balancing in 

the Network Routing Options. For more information on these 
routing options, see the “Network Routing Options” section in 
Chapter 3. 

• If you are creating a 1x1 configuration, the only selectable 

routing type is Dedicated Circuit. All other options in this 
dialog box are grayed out and ignored.

• The options selectable from this dialog box are limited by 

the license key for the node. If the license key does not 
provide support for the Fail Over and Load Balancing 
network routing types, only the Dedicated Circuit network 
routing type is selectable, and all other options on this 
dialog are grayed out.

• If you have not entered the licensing information for each 

node in the circuit using the License Wizard, only the 
Dedicated Circuit network routing type is selectable from 
this dialog box.

• If you want to change the Network Routing Type after you 

have created the data paths, double-click the F/C interface 
on the Network Map. Click the Network button at the 
bottom of the F/C interface dialog box (FC10 - Node10) 
and select the Network Routing Type. You do not need to 
create the data paths again to change the Network Routing 
Type.

6. Click Next.