McDATA 3000 Manual Do Utilizador

 

4. Setting the Initial Configuration

5. Setting the License Information

6. Adding an IP Circuit

7. Creating a Data Path for Fibre Channel Device Extension 

Interfaces

a. Optional Step: Static Mapping the LUNs and Filtering the 

Source WWN

8. Delivering the Configured Network

Fibre Channel Switch Zoning, Static Edge LUN Mapping, and Source 

WWN Filtering may or may not be needed depending upon the type of 
network you are configuring. If Fibre Channel Switch Zoning is needed, do 
this step before using UCM to configure the Edge. See the sections, “Required 
Static Edge LUN Mapping” (page -5) and “Required Source WWN Filtering” 
(page -7) to determine if these steps are needed.

There are three different examples shown in the “Network 
Configuration Examples” section, to be used as references to 
determine when Fibre Channel switch zoning, statically mapping the 
LUNs, and source WWN filtering are required. 

If your network requires static mapping or source WWN filtering, 
perform all the steps shown in the above list including the optional 
step “Static Mapping the LUNs and Filtering the Source WWN”. 
Perform the “Delivering the Configured Network” step last.

For help on the configuration process, click the Help button in UCM 

on the active dialog box or press the F1 key.

Before starting the configuration procedure in ConfigManager you 
will need to gather the IP addresses for your network. The IP host 
addresses and the completed UltraNet Edge Storage Router 
Configuration IP Address Worksheet from Appendix J will be used in 
the configuration process. The worksheet is referred to as the 
Configuration IP address Worksheet throughout the remainder of this 
chapter.

You will need the following addresses:

•

UltraNet Edge 3000 Ethernet Maintenance Interface host IP 
address