McDATA 3000 Manual Do Utilizador

 

Figure 8-4 is an example of the main window in ConfigManager 
(UCM).

Use the following procedures to create a sample network map for a 
1x1 10/100 Ethernet WAN configuration. This configuration will 
have two nodes that extend one Fibre Channel device extension 
interface over one 10/100 Ethernet WAN. 

The procedure that follows is for a 1x1 configuration. 

1. Select the Nodes tab located on the toolbar between the TreeView 

 and the Network Map Area (see Figure 8-4 on page -11).

The Nodes tab displays three drop-down menus. Each contains 
the node types for the available Edge series.

2. Click the arrow next to the UltraNet Edge 3000 Series drop-down 

menu and select the Edge3000 (1x1 - 10/100 Mbps Ethernet) node 
type.

This example is for a 1x1 Ethernet 10/100 WAN configuration. If you 

are configuring any other model, choose the appropriate node icon shown in 
the table above to create your map.

The cursor will turn into crosshairs once you move the cursor 
over the map area. The cursor must be crosshairs to complete the 
current operation.

3. Click in the Network Map Area to create an instance of the 

UltraNet Edge 3000 node.

Adding a Fibre Channel Interface

Links tab
Interface tab
Nodes tab

UltraNet Edge 1000 Series

UltraNet Edge 3000 Series