McDATA 3000 Manual Do Utilizador

McDATA UltraNet Edge 3000 User Guide

9. After the 

tarExtract

 command is complete, issue a 

command to boot up the UltraNet Edge 3000.

10. Remove any files that were renamed in step .

11. Immediately telnet to the UltraNet Edge 3000 that has just been 

upgraded. You will be prompted for a login and password. 

The login is root and the password is what has been defined for 
the node. The default password for prom is shadow.

12. After issuing the 

reset

 command, press 

 to go into prom 

.

13. Issue the 

 command at the prom prompt. 

14. Issue the 

 command after the 

flash_html “romx” 

is 

complete.

1. Using the most current version of UCM, deliver the new 

configurations to the UltraNet Edge 3000 that has just been 
upgraded. 

The UltraNet Edge 3000 will be rebooted after a successful 
delivery.

This section explains all of the steps required to replace the chassis 
and upgrade your UltraNet Edge 3000 to the most current software 
version, from a remote location. This procedure is applicable when 
initiated remotely by McDATA Technical Support.

This upgrade procedure only applies to UltraNet Edges currently at 

version 3.1.1.1 or higher and is intended to be done from a remote location.

There are several short procedures required for upgrading the 
UltraNet Edge 3000 from a remote location. Follow the steps 
summarized below:

1. <blue>Request License Key from Technical Support

2. <blue>Obtain Current Version of UltraNet ConfigManager

3. <blue>Power Down the UltraNet Edge 3000 Unit

If you do not reset the UltraNet Edge 3000 after the tarExtract command is completed, the 

box will hang and the prom will be corrupted. This state is unrecoverable.