McDATA 3000 Manual Do Utilizador

 

4. <blue>Replace the UltraNet Edge 3000 Chassis and Update UCM

5. <blue>FTP the New UltraNet Edge 3000 Software

6. <blue>Install the New UltraNet Edge 3000 Software

7. <blue>Deliver the Configurations

When an UltraNet Edge 3000 chassis is replaced, McDATA Technical 
Support will need to create a License Key for the new hardware 
replacement. The License Key is based on the serial number of the 
new unit and feature functionality that was originally ordered with 
the unit.

Obtain the most current version of UltraNet ConfigManager (UCM) 
from McDATA and install it on the Windows PC used to configure 
the network. 

Use the following procedure to power down the UltraNet Edge 3000:

1. Direct the on-site technician to power off the UltraNet Edge 3000 

that is being replaced.

2. Direct the on-site technician to remove all cabling.

3. Direct the on-site technician to remove all applicable interface 

cards.

4. Direct the on-site technician to remove the unit.

Use the following procedure to replace the new UltraNet Edge 3000 
chassis and update UCM:

1. Direct the on-site technician to replace the old unit with the new 

UltraNet Edge 3000 chassis.

2. Direct the on-site technician to replace all cabling.

3. Direct the on-site technician to replace all applicable interface 

cards.

4. Direct the on-site technician to power on the unit.

5. Using terminal emulation, dial into the new UltraNet Edge 3000. 

6. Issue the 

 command to configure the Ethernet 

maintenance interface IP host address, default gateway, and 
subnet mask.

7. Issue the 

 command to reboot the UltraNet Edge 3000.