McDATA 3000 Manual Do Utilizador

12-12

McDATA UltraNet Edge 3000 User Guide

10/100 Ethernet Interface Card Installation Procedure

6. Carefully pull the 10/100 Ethernet interface card up. The 10/100

Ethernet interface card is connected to two socketed connectors.

7. Remove the 10/100 Ethernet interface card from the chassis.

8. Follow the 10/100 Ethernet Interface Card Installation Procedure

to install the new 10/100 Ethernet interface card.

10/100 Ethernet Interface Card Installation Procedure

Use the following procedure to install the 10/100 Ethernet interface
card into the UltraNet Edge 3000 chassis.

Tools required:

A small Phillips screwdriver and an adjustable

Torque driver, rated between 3 and 15 in-lbs.

CAUTION

Make sure the power is off. Attach a wrist strap and follow ESD
procedures (see page B-19) during the handling of all electronic
components.

1. Carefully insert the 10/100 Ethernet interface card in either I/O 3

or I/O 4.

For I/O 3, the 10/100 Ethernet interface card will plug into
location J8 and J9 on the motherboard. If the 10/100 Ethernet
interface card is being installed into I/O 4, plug it into location J10
and J11 on the motherboard.

Sb1

10/100 Ethernet
Interface Card

Screw (2)

I/O 4

I/O 2

I/O 1

I/O 3