Netgear EX6100100NAS Manual Do Utilizador

The extender connects to your network’s WiFi signal and then rebroadcasts that signal to 
extend the WiFi signal coverage.

NETGEAR recommends that you place the extender near the router during initial setup. Then 
you can move it farther away from the router as needed to increase the area that has a WiFi 
signal.



Place your extender in the same room as your WiFi router.

Plug the extender into an electrical outlet.

The Power LED

lights green. If the Power LED does not light, press the Power 

button.

Make sure that the switch on the extender is set to Extender.

To extend the range of your WiFi network, you must connect the extender to your existing 
WiFi network. You can do this in one of two ways:

Connect with WPS. For more information, see 

10.

Connect with genie Smart Setup. For more information, see 

Wi-Fi Protected Setup (WPS) lets you join a secure WiFi network without typing the network 
name and password. The WPS button is a physical button on the router or access point. 
WPS does not support WEP network security. If you are using WEP security, see 



Press the WPS button on the side panel of the extender.

The WPS LED

blinks.

Within two minutes, press the WPS button on your router or access point.

The WPS LED on the extender lights solid green, the Router Link LED

 lights, and 

the extender is connected to your existing WiFi network.

If the Router Link LED does not light, try again. If it still does not light, 
see 

11.