Enterasys Networks 1G58x-09 Manual Do Utilizador

Before you can use the Matrix E1 device for IP routing, you must dedicate two or more VLANs as 
IP routing uplinks. To do this, you must

1. Disable Spanning Tree on the ports to be dedicated as routing uplinks.

2. Create new VLANs from these dedicated ports.

3. Disable GVRP on the dedicated ports.

4. In router mode, assign IP addresses to the new VLANs, enable them for IP routing, and save the 

routing configuration to NVRAM.

The commands needed for this process are listed in 

, and are described in the associated 

sections as shown.

Disable Spanning 
Tree on the dedicated 
routing port.

set spantree 
portadmin 
port-string 
disable

Switch:
(Matrix>)

Create a new IEEE 
802.1Q VLAN or 
enable an existing 
VLAN on the 
dedicated routing 
port. 

set vlan {create | 
enable} vlan_id

Switch:
(Matrix>)

Set the port’s VLAN 
identifier (vlan_id).

Enter y when 
prompted to add the 
port to the VLAN’s 
untagged egress list 
and remove it from 
all other VLANs’ 
untagged egress lists.

set port vlan 
port-string 
vlan_id

Switch:
(Matrix>)