Fortinet 127 Manual Do Utilizador
NAT/Route mode installation
Configuring the FortiGate unit to operate in NAT/Route mode
FortiGate-500A Installation Guide
01-28005-0101-20041015
29
To add a default gateway to an interface
The default gateway is usually configured for the interface connected to the Internet.
You can use the procedure below to configure a default gateway for any interface.
You can use the procedure below to configure a default gateway for any interface.
1
Press Enter to display the interface list.
2
Use the down arrow key to highlight the name of the interface connected to the
Internet and press Enter.
Internet and press Enter.
3
Use the down arrow to highlight Default Gateway.
4
Press Enter and set the default gateway.
5
After you set the last digit of the default gateway, press Enter.
6
Press Esc to return to the Main Menu.
You have now completed the initial configuration of the FortiGate unit and you can
proceed to
proceed to
.
Using the command line interface
You can also configure the FortiGate unit using the command line interface (CLI). For
information about connecting to the CLI, see
information about connecting to the CLI, see
.
Configuring the FortiGate unit to operate in NAT/Route mode
Use the information that you gathered in
Table 5 on page 26
to complete the following
procedures.
To add/change the administrator password
1
Log in to the CLI.
2
Change the admin administrator password. Enter:
config system admin
edit admin
set password <psswrd>
end
To configure interfaces
1
Log in to the CLI.
2
To set the IP address and netmask of the LAN interface, enter:
config system interface
edit lan
set ip <address_ip> <netmask>
end