Avaya G450 Manual Do Utilizador

IP interfaces represent the logical connections of the device to the IP nets/subnets attached to 
it. Each IP interface corresponds to one net/subnet.

You can create either a static IP interface or an unnumbered IP interface. When you create a 
new IP interface, RIP and OSPF interfaces are automatically created and assigned enable 
status. When you delete an IP interface, the device deletes the associated RIP and OSPF 
interfaces.

Note:

An IP unnumbered interface can be configured on point-to- point Interfaces only. 
An IP unnumbered interface supports all the parameters of a static PPP IP 
interface except for Broadcast address, which cannot be configured on IP 
unnumbered interfaces.

To create entries in the IP interface table, first specify whether the interface is static or 
unnumbered using the Type field (the default value is static). Then configure the following 
fields:

●

If you are configuring a static interface, configure the fields IP Address, IP Netmask, and 
Layer 2 Interface Name.

●

If you are configuring an unnumbered interface, configure the fields Layer 2 Interface 
Name and Reference Layer 2 Interface Name. There is no need to configure IP address 
and IP Netmask. 

To define and display the IP interfaces:

Select IP Route > IP Interfaces. The IP Interfaces window opens.

The following parameters are displayed:

The name assigned to the selected IP interface.

The IP address assigned to the device on this subnet.

The IP address borrowed for an unnumbered IP interface. If the IP 
address is not unnumbered this field returns a value of N/A.