ONKYO TX-NR808 Manual Do Utilizador

En

• Make the room as quiet as possible. Background noise and Radio 

Frequency Interference (RFI) can disrupt the room measure-
ments. Close windows, televisions, radios, air conditioners, flu-
orescent lights, home appliances, light dimmers, or other 
devices. Turn off the cell phone (even if it is not in use) or place 
it away from all audio electronics.

• The microphone picks up test tones which played through each 

speaker as Audyssey MultEQ

®

 Room Correction and Speaker 

Setup run.

• Audyssey MultEQ Room Correction and Speaker Setup cannot 

be performed while a pair of headphones is connected.

Turn on the AV receiver and the connected TV.
On the TV, select the input to which the AV receiver 
is connected.

a, and connect it to the SETUP 

The speaker setting menu appears.

• If your front speakers are bi-amped, you must 

select “Bi-Amp” in the “Speakers Type(Front)” 
setting (

45). For hookup information, see “Bi-

• If you change “Powered Zone2” setting, refer to 

“Setting the Powered Zone 2” for more details 
(

• If you are using a subwoofer(s), select “Yes” in the 

“Subwoofer” (

46). If not, select “No” and skip 

step 4.

TV

d e f
c a b

: Listening area

a to f: Listening position

Speaker setup microphone

SETUP MIC jack

If you use a powered subwoofer(s), adjust the sub-
woofer volume level to 75dB.
Test tones are played through the subwoofer. Use the 
volume control on the subwoofer.

• If your subwoofer does not have a volume control, disre-

gard the level displayed and press ENTER to proceed to 
the next step.

• If you set the subwoofer’s volume control to its maximum 

and the displayed level is lower than 75 dB, leave the sub-
woofer’s volume control at its maximum and press 
ENTER to proceed to the next step.

Audyssey MultEQ Room Correction and Speaker 
Setup starts.
Test tones are played through each speaker as 
Audyssey MultEQ Room Correction and Speaker 
Setup runs. This process takes a few minutes. Please 
refrain from talking during measurements and do 
not stand between speakers and the microphone.
Do not disconnect the speaker setup microphone 
during Audyssey MultEQ Room Correction and 
Speaker Setup, unless you want to cancel the setup.

Audyssey MultEQ performs more measurements. 
This takes a few minutes.

q/w to select an option, and then press 

The options are:

`

Save: 

Save the calculated settings and exit 
Audyssey MultEQ

 Room Correction and Speaker 

Setup

.

`

Cancel: 

Cancel Audyssey MultEQ

 Room Correction and 

Speaker Setup

.

• You can view the calculated settings for the speaker con-

figuration, speaker distances, and speaker levels by using 
e/r.

TV