Avaya X330W2-DS1 Manual Do Utilizador

WAN CLI Commands

Avaya X330W-2DS1 User’s Guide

135

Use this command during line set up and maintenance.

The syntax for this command is:

Use the loopback local command to put the T1 or E1 line into loopback mode.

Regarding the use of loopbacks during line setup and maintenance, only one 

type of loopback can be defined at any given time.

Use this command during line set up and maintenance.

The syntax for this command is:

 {line|payload}

Example:
X330WAN-2DS1-1(config-controller:1)#loopback local line

Use the loopback remote command to ask the far end to put itself into loopback 
mode.

Note:  
1.  This command can only be performed if the controller is set to T1.
2.  Use this command during line set up and maintenance.

line

The controller loops the external line signal back toward the 
network without reframing the DS1 signal.

payload

The controller loops the external line signal back toward the 
network and reframes the DS1 signal.