Avaya X330W2-DS1 Manual Do Utilizador

WAN CLI Commands

Avaya X330W-2DS1 User’s Guide

145

The syntax for this command is:
show interfaces 

[<type>] [<identifier>]

Examples:

X330WAN-2DS1-1(super)# show interfaces

FabricFastEthernet 1:1 is up, line protocol is up

 Physical address is 00.40.0d.bf.3b.01,

 MTU 1500 bytes, Bandwidth 100000 Kbit,

 Encapsulation ARPA,

 0 packets input, Received 0 broadcasts,

 33175 input errors,

 0 packets output,

 0 output errors

FastEthernet 1 is up, line protocol is up

 Physical address is 00.40.0d.bf.3b.fe,

 Internet address is 149.49.75.71   , mask is 255.255.255.0

 MTU 1500 bytes, Bandwidth 100000 Kbit,

 Encapsulation ARPA,

 Full-duplex, 100Mb, 100BaseTX/FX

 ARP type: ARPA, ARP Timeout 04:00:00

 680031 packets input, Received 661406 broadcasts,

 17 input errors,

 5569 packets output,

 0 output errors

FabricFastEthernet 1 is up, line protocol is up

 MTU 0 bytes, Bandwidth 100000 Kbit,

 Encapsulation ARPA,

 0 packets input, Received 0 broadcasts,

 0 input errors,

type

The type of this interface. Select one of the following: 
FastEthernet | Serial | FabricFastEthernet | Loopback | Console

identifier

• For a FastEthernet interface - An integer (1)
• For a Serial interface - <port>:<channel-group>

                                       <port> - Either 1 or 2
                                       <channel-group> -  For E1, an integer, 0-30
                                                                                  For  T1, an integer, 0-23

• For a FabricFastEthernet interface - 1[:<vlan>]

                                                                    <vlan> - An integer, 1-3071

• For a Loopback interface - An integer, 0-99