Yamaha YSP-40D Manual Do Utilizador

The results of the AUTO SETUP procedure are 
displayed on your TV.

y

• If “ENVIRONMENT CHECK [FAILED]” is 

displayed, we recommend running the AUTO SETUP 
procedure again. For details, see step 9.

• If “SUBWOOFER : NOT APPLICABLE” is displayed 

even though a subwoofer is connected to this unit, 
increase the volume level of the subwoofer and run the 
AUTO SETUP procedure again.

• Depending on the environment of your listening room, 

the beam angle of front left and right, and surround left 
and right may be set to the same value even if 
“5 BEAM” is displayed as a result.

The following screen is displayed for two seconds 
and then disappears from your TV.

If “ENVIRONMENT CHECK [FAILED]” is displayed in 
step 8, the following screen is displayed after pressing 
ENTER. In this case, see ERROR E-1 in “Error messages 
for AUTO SETUP” on page 40. Press ENTER to exit 
AUTO SETUP and then run the procedure again from 
step 3.

y

If you want to save and load settings, see “Using the system 
memory” on page 41.

MEASUREMENT COMPLETE

BEAM MODE

:5 BEAM

SUBWOOFER :NOT APPLICABLE

[ENTER]:Save set-up.

[RETURN]:Do not save set-up.

SHOW RESULT

←

MEASUREMENT COMPLETE

ENVIRONMENT CHECK[FAILED]

BEAM MODE

:5 BEAM

SUBWOOFER :YES

[ENTER]:Save set-up.

[RETURN]:Do not save set-up.

SHOW RESULT

←

AUTO SETUP COMPLETE

Please remove the MIC from

the YSP and the listening
position.

AUTO SETUP COMPLETE

Your YSP unit may not be set
up correctly.
We recommend you try again.

Please press [ENTER] key to
exit.