Sanyo QXXAVC922---P Manual Do Utilizador

 Click page [3] of setting pages.  Following wireless LAN security 
setting can be done. After completing the configuration, press 
Set button.

Network security ...Sets the type of encryption. Following types are available.
 

WEP64(40)bit Open

 

WEP64(40)bit Share

 

WEP128(104)bit Open

 

WEP128(104)bit Share

 

WPA-PSK(TKIP)

 

WPA2-PSK(AES)

Input type.................ASCII or HEX. See item "Notes for entering characters"
Key index1 - 4..........Enter keys of encryption.
 

 The used number of character changes as the table below according to the type 
of WEP encryption and input type.

WEP option

Characters

WEP64(40)bit ASCII
WEP64(40)bit HEX
WEP128(104)bit ASCII
WEP128(104)bit HEX

5 characters
10 characters
13 characters
26 characters

Four 

key indexes can be set, however, the only one with check on its radio 

button is effective. Both of the number and value of the key index in effect must 
be same as those of your computer and the access point.

Depending on computers and access points, you may be allowed to select only 
one WEP key. In that case, use key index1.

PSK ..............................Available when the "WPA-PSK(TKIP)" or "WPA2-PSK(AES)" is selected.
 

 The PSK key must be no fewer than 8, nor more than 63 digits with ASCII code, 
and 64 digits with Hex code.

The “¥” symbol is displayed as “\” when the ASCII key is used. The “]” symbol is treated as a character 
by the ASCII key, but it is not interpreted as a character by the HEX key. In HEX, the “]” symbol is 
displayed in red and setting is denied.
You can not set all the characters with the “]” symbol. It will be considered as no operation.
ASCII key characters : Space - 0 to 9 A to Z a to z ! " # $ % & ' ( ) * + , . / : ; < = > ? @ [ ¥ ] ^ _ ` { | } ~
HEX key characters : 0 to 9 a to f