Sanyo QXXAVC922---P Manual Do Utilizador
Chapter 6 Basic setting and operation
2
Registering and deleting E-mail addresses
Click "Add E-mail address" and type the E-mail address onto the
text box and click Set button. To check the registered addresses,
click Check/Delete sub menu tab. The addresses are listed as the
figure on the right.
text box and click Set button. To check the registered addresses,
click Check/Delete sub menu tab. The addresses are listed as the
figure on the right.
✐
Up to 10 E-mail addresses can be registered.
To delete the registered addresses, check the address you want to
delete and click Delete button.
delete and click Delete button.
3
Option selection for sending alert mail
Click Option sub menu tab. Check the condition items under
which alert mail will be sent and click Set button.
which alert mail will be sent and click Set button.
Please refer to the item "Examples :Type and contents of alert
mail" described on the next page.
mail" described on the next page.
Check / Delete
Option
[1]––––––––––––––––––––––––––––––––––
o
o
When PJ lamp is off.
o
When PJ lamp replacement time is reached.
o
When internal PJ power circuit is failed.
o
When internal PJ temperature is too high.
o
When PJ is turned into Standby in proper user
operation.
operation.
[2]––––––––––––––––––––––––––––––––––
o
o
When accumulated filter use time reaches
[ ] hours.
o
When Power management function turns PJ
lamp off.
o
When the signal is interrupted.
o
When Auto Play is failed.
[3]––––––––––––––––––––––––––––––––––
o
o
When lamp Corres. Value reaches
[ ] hours.
Attached message
Attached message
✐
If condition "When Auto Play is failed" is checked, the
trap is sent when the error occurs during the auto
display operation using with the network viewer
function (+p.109). For further information of the
error, refer to item "Auto Display setting and control
page [3]"(+p.124).
trap is sent when the error occurs during the auto
display operation using with the network viewer
function (+p.109). For further information of the
error, refer to item "Auto Display setting and control
page [3]"(+p.124).
✐
The length of message should be less than 255
characters.
characters.
✐
Up to 99,999 hours can be set for use time.