Sanyo PLC-WXU30 Manual Do Utilizador

Turn off the projector, and unplug the AC power cord 

from the AC outlet.
Turn the projector over and remove the filter by pulling 

the latches upward.

Filter prevents dust from accumulating on the optical elements inside the projector. Should the filter become 

clogged with dust particles, it will reduce cooling fans’ effectiveness and may result in internal heat buildup 

and adversely affect the life of the projector. If a “Filter warning” icon appears on the screen, clean the filter 

immediately. Clean the filter by following the steps below.

Gently clean the filter by using a brush or rinse it softly.

When rinsing the filter, dry it well. Replace the filter 

properly. Make sure that the filter is fully inserted to the 

projector.

Do not operate the projector with the filter removed. 

Dust may accumulate on the optical elements 

degrading picture quality.

Do not put anything into the air vents. Doing so 

may result in malfunction of the projector.

  When using the projector under dusty or smoky conditions, 

dust may accumulate on a lens, LCD panels, or optical 

elements inside the projector degrading the quality of a 

projected image. When the symptoms above are noticed, 

contact your authorized dealer or service station for proper 

cleaning.

✔

  • When reinserting this filter, be sure that 

the slit part is facing the outer side.

Be sure to reset the Filter counter after cleaning or replacing the filters. 

Press the MENU button to display the On-Screen 

Menu. Use the Point 

7 8

 buttons to move the red 

frame pointer to the Setting Menu icon.
Use the Point 

ed

 buttons to move the red frame 

pointer to Filter counter and then press the SELECT 

button. A dialog box appears showing the total 

accumulated time of the filter use, a timer setting 

option, and the reset option. Select Reset and the 

“Filter counter Reset?” appears. Select [Yes] to 

continue.

Select Reset and the “Filter 

counter Reset?” appears.

Select [Yes], 

then another 

confirmation 

box appears.

Select [Yes] again to reset 

the Filter counter.

Another confirmation dialog box appears, select [Yes] 

to reset the Filter counter.

Filter
Pull up and remove.