Sanyo PLC-WXU30 Manual Do Utilizador

When the projection lamp of the projector reaches its end of 

life, the Lamp replacement icon appears on the screen and 

LAMP REPLACE indicator lights yellow. Replace the lamp with 

a new one promptly. The timing when the LAMP REPLACE 

indicator should light is depending on the lamp mode.

Follow these steps to replace the lamp.

Lamp

Replacement lamp can be ordered through your dealer.  When ordering a projection lamp, give the following 

information to the dealer.

●

 

●

 

 

     

 

 

 

 

       

   (Service Parts No. 610 333 9740)

For continued safety, replace with a lamp of the 

same type. Do not drop a lamp or touch a glass 

bulb! The glass can shatter and may cause injury.

Allow a projector to cool for at least 45 minutes 

before you open the Lamp cover. The inside of the 

projector can become very hot.

Screw

Turn off the projector and unplug the AC power cord. 

Let the projector cool for at least 45 minutes.

Remove the two (2) screws that secure the lamp. Lift 

the lamp out of the projector by using the handle.

Replace the lamp with a new one and secure the two 

(2) screws. Make sure that the lamp is set properly. 

Close the lamp cover and secure the screw.

Remove the screw and open the lamp cover.

Connect the AC power cord to the projector and turn 

on the projector.

See “Resetting the Lamp Counter” on the next page.

Handle

Screw

Lamp Cover

WARNING: 

TURN OFF THE UV LAMP BEFORE 

OPENING THE LAMP COVER

Lamp replacement icon

Press here and pull upward.

✔

  • The Lamp replacement icon will not appear when the 

Display function is set to “Off” (p.48), during “Freeze” 
(p.28), or “No show” (p.29).

Screw