Sanyo 1AV4U19B25500 Manual Do Utilizador

Setting procedures and contents differ depending on the LAN installation location.  
When installing, consult your system administrator to set up the LAN appropriately.

Connect the shielded LAN cable to the LAN connection terminal of the projector.

Set the Wired LAN network through the projector menu. Detailed network settings will be made with 
browser. Refer to “6. Basic setting and operation” (p45-64). First, complete the settings described in this 
chapter before performing steps in “6. Basic setting and operation.”

1. Turn on the projector and select “Network” from the input menu of the projector.
2. Select “LAN mode select” in the Network menu, and press Point  8 or SELECT button.
3.  Select similar LAN environment among Wired1, 2 and 3 with the Point ed buttons. Then the Menu 

will disappear, the “Please wait...” message will appear, and switching operation will start. Switching 
will take a while and after completing the operation, the “Ready for use” message will appear, and the 
projector’s LINK/ACT Lamp will be on or blink.

LAN Cable**

LAN Connection
Terminal

* When the LAN setting is “Off”, the two lamps will not be on.

ACT Lamp (Orange)
When the projector is 
connected to the 100 Base-
TX network, light or blink as 
follows;
-  Light when connecting to 

the network.

-  Blink when sending or 

receiving the data. 

LINK lamp (Green)
Light green when the 
projector is connected to the 
network.

** Please use a shielded LAN cable .