Viewsonic VS13835 Manual Do Utilizador

Setting input ports using menu

250

ViewSonic

Pro9500

5.3 Starting up Main projector

After performing section 5.2 Checking Main projector's operating status, the two

projectors are confirmed to have been set to ALTERNATE mode and the Sub

projector is currently operating. As the settings for Intellectual Stack can be

changed only when the Main projector is operating, this section explains how to

switch from the Sub projector to the Main projector.

Use the ▲/▼/◄/► buttons to go into the following menu.

ADVANCED MENU > OPTION

> SERVICE > COMMUNICATION > STACK

STACK menu will appear on screen. (Oper-

ating Guide → OPTION menu)

Check the ALTERNATE MODE setting in the menu.

If NORMAL is displayed, the two projectors are turned on alternately. Therefore,

the Main projector will be turned on if you restart the projectors.

(1) Press the

STANDBY/ON button on the remote control or control panel of the

Main projector, the Sub projector will turn off.

(2) After the projector has cooled down, press the

STANDBY/ON button to turn on

again. The Main projector will be turned on.

If AUTO is displayed, the projector with the least lamp usage is turned on.

Therefore, the Main projector may not be turned on even if you restart the

projectors. Follow the procedures below to turn on the Main projector.

(1) Use the ▲/▼ button to highlight STACK MODE, and press the ► button to

display the STACK MODE dialog.

(2) Use the ▲/▼ button to highlight OFF, and then press the ► button to complete

the setting.

(3) Repeat the above procedures to display the STACK MODE dialog again.

(4) Use the ▲/▼ button to highlight SUB, and then press the ► button to

complete the setting.

(5) After exiting the menu, wait for 10 seconds or more.

(6) Press the

STANDBY/ON button on the remote control or control panel of the

Main projector, the Sub projector will turn off.

(7) After the projector has cooled down, press the

STANDBY/ON button to turn on

again. The Main projector will be turned on even if LAMP MODE has been set

to AUTO.

You can change the settings for Intellectual Stack now that the Main projector

is operating. Go to 5.4 Setting the menu.

NOTE

• If the Main projector cannot be turned on due to error or certain

problems, the Sub projector will be turned on even if you follow the procedures

above. Take necessary actions to fix the Main projector, and then change the

settings for Intellectual Stack.