EIKI LC-WUL100L Manual Do Utilizador

Open the battery 

compartment lid.

Install new batteries into 

the compartment.

Replace the 

compartment lid.

For correct polarity 

(+ and –), be sure 

battery terminals are 

in contact with pins 

in the compartment.

To ensure safe operation, please observe the following precautions :

  ●  Use two (2) AAA or LR03 type alkaline batteries.

  ●  Always replace batteries in sets.

  ●  Do not use a new battery with a used battery.

  ●  Avoid contact with water or liquid.

  ●  Do not expose the remote control to moisture or heat.

  ●  Do not drop the remote control.

  ●  If the battery has leaked on the remote control, carefully wipe the case clean 

and install new batteries.

  ●  Risk of an explosion if battery is replaced by an incorrect type. 

  ●   Dispose of used batteries according to the instructions or your local disposal 

rule or guidelines.

Point the remote control toward the projector (to 

Infrared Remote Receivers) when pressing the buttons. 

Maximum operating range for the remote control is 

about 16.4’ (5 m) and 60 degrees in front, back and top 

of the projector.

Infrared Remote Receivers are provided in front, back 

and top of of the projector. You can conveniently use all 

of the receivers (pp. 10, 11, 59).

16.4’

(5 m)

The remote control can be used as a wired remote 

control. Wired remote control helps you use the remote 

control outside of the operating range (16.4’/ 5 m). 

Connect the remote control and the projector with the 

remote control cable (supplied). Connected with the 

remote control cable, the remote control does not emit 

wireless signal.

16.4’

(5 m)



    When hanging the projector from the ceiling, select

15