Sony STRDN1020 Manual Do Utilizador

D:\NORM'S JOB\SONY HA\SO0155\STR-DN1020_PMRF 03\4273051141_GB\GB07ADD_STR-
DN1020-CEL.fm

STR-DN1020

4-273-051-14(1)

 

 

 

 

 

 

 

 

 

 

• Check that the antennas (aerials) are 

connected securely. Adjust the antennas 
(aerials) and connect an external antenna 
(aerial), if necessary.

• Keep the satellite radio antenna, away 

from the speaker cords and the power cord 
to avoid picking up noise.*

• The signal strength of the stations is too 

weak with automatic tuning. Use direct 
tuning.

• Make sure you set the tuning scale 

correctly (when tuning in AM stations 
with direct tuning) (page 56).

• No stations have been preset or the preset 

stations have been cleared (when tuning 
by scanning preset stations is used). Preset 
the stations (page 56).

• Press AMP, then press DISPLAY 

repeatedly on the remote control so that 
the frequency appears on the display 
panel.

The receiver cannot receive satellite 
channels at all.*

• The receiving condition is not good. Move 

the antenna to the place where the 
condition is good.

• Check that you subscribed to the satellite 

radio service you want (page 58).

RDS does not work.**

• Make sure that you are tuned to an FM 

RDS station.

• Select a stronger FM station.

The RDS information that you want 
does not appear.**

• The service may be temporarily out of 

order. Contact the radio station and find 
out whether they actually provide the 
service in question.

* USA and Canada models only.
**Europe and Australia models only.

• Press MASTER VOL – or 

2

 – on the 

remote control repeatedly.

• Set the “EQ” setting of the iPhone/iPod to 

“Off” or “Flat”.

• Check that the receiver is turned on.
• Make sure the iPhone/iPod is connected 

firmly.

• Check that you have removed the protect 

case of the iPhone/iPod.

• Depending on the contents of the iPhone/

iPod, it may take time to start playback.

• Disconnect the iPhone/iPod and connect 

the iPhone/iPod again.

• You are using an unsupported iPhone/

iPod. See “Compatible iPod/iPhone 
models” (page 49) for the supported 
device types.

• Adjust the ring volume using the controls 

on the iPhone.

• If you connect an unsupported USB 

device, the following problems may occur. 
See “Compatible USB devices” (page 52) 
for the supported device types.
– The USB device is not recognized.
– File or folder names are not displayed 

on this receiver.

– Playback is not possible.
– The sound skips.
– There is noise.
– A distorted sound is output.