Star Micronics LC-8211+ Manual Do Utilizador

Página de 109
17
Chapter 2:  Control Panel Operations
The control panel gives you push-button control over the printer’s power and 
paper feed operations. It also includes indicator lights, which tell you the current 
status of the printer at a glance.
This chapter describes general functions that can be performed using the control 
panel buttons while the printer is turned on and either on-line or off-line. The 
buttons perform different functions in the EDS and Dot Adjustment Modes. 
Functions of control panel buttons in these modes are described in the relevant 
sections covering them.
Important!
The procedures described in this chapter will not work if paper is not loaded 
into the printer. Be sure to use the procedures on page 9 of this manual to load 
paper before trying any of the following operations.
Switching between on-line and off-line 
Press 
ON LINE
 to switch the printer between being on-line and off-line.
When the printer is on-line, the 
ON LINE
 indicator is lit and the printer can 
receive data from the computer. You should make sure that the printer is on-
line whenever you are trying to print.
When the printer is in off-line, the 
ON LINE
 indicator goes out, which 
means that the printer cannot receive any data.
Important!
Make sure that the on-line/off-line setting of the printer is correct before 
performing any other control panel operations.
FONT
MODE
LF
ON LINE
ROMAN
COURIER
SANSERIF
PRESTIGE
ORATOR
POWER
DRAFT
QUIET
BANK
SW
A
1
B
2
C
3
D
4
E
5
6
F
MICRO FEED
FF
QUIET