EMSA HS500E Manual Do Utilizador
C H A P T E R 5 : E T H E R N E T / I P P R O T O C O L
5 . 2 . 2
O n D e m a n d N o d e 0 1 C o n f i g u r a t i o n P a g e
The OnDemand Node 01 Configuration Page
Use this page to modify the settings for Node 01.
Controller Settings
5 Select the Controller Type from the drop-down menu. The Controller Type
(in this case) specifies the type of PLC that will be communicating with the
HS500E.
HS500E.
6 Enter the Controller’s IP address. Controller IP address is the IP address
assigned to the PLC.
7 Enter the Controller’s Slot Number (0-255). Controller Slot Number
indicates where in the PLC rack the controller module is installed; normally
slot 0 for ControlLogix.
slot 0 for ControlLogix.
Write Settings
8 Specify the number of words (between 1 and 100, 0 = disabled) for the Max
Write Size. The Max Write Size value represents the maximum number of 2-
byte “words” that the HS500E will attempt to write to PLC memory during
each command-response cycle. Note: the actual data size required on the
PLC is 3 words larger than the value specified in this field.
byte “words” that the HS500E will attempt to write to PLC memory during
each command-response cycle. Note: the actual data size required on the
PLC is 3 words larger than the value specified in this field.
H S 5 0 0 E – O P E R A T O R ’ S M A N U A L
P / N : 1 7 - 1 3 0 5 R E V 0 2 ( 1 2 - 0 5 )
P A G E 4 2 O F 8 2